3/21/2023 0 Comments Silkscreen stencilsSecurely tighten your silkscreen with the photographic image exposed on it in the hinge clamps. Tape the edges of the screen with the two-inch tape on both sides (as in step one).To print layer four, the final photographic image, register your film positive to your print using small pieces of painter’s tape to secure it to the print.Once it is in the correct place, use two small pieces of painter’s tape to secure it to the print. When layer two of your print is dry, register your next stencil (layer three) to the film positive.When layer one of your print is dry, register your next stencil (layer two) to the film positive.Making sure the silkscreen is completely dry, place your taped silkscreen into the hinge clamps and securely tighten the clamps.The two-inch tape you placed around the edges of the silkscreen in step eleven should remain until you are finished printing your entire print. Clean the open silkscreen and squeegee thoroughly.Remove the stencil from the silkscreen and discard.Continue this process, placing each piece of paper inside the tape corners until all ten pieces of paper are printed.For large areas of color you may need to make two passes (or more) with the squeegee.Starting from a top corner, slowly peel the stencil away from the screen. The stencil will stick to the back of the silkscreen because the ink acts as an adhesive.Carefully close the screen over the stencil paper and print the first color using enough ink for adequate coverage.Take care to not move the stencil from its position. Carefully remove the small pieces of blue painter’s tape holding the film positive in place on the paper. Now place your stencil over your film positive to register your stencil.This will show you where to put the paper for each print. Use the blue painter’s tape to mark the edges of your paper on the table you are printing on. Place your paper with the film positive under your screen and register the open screen to the edges of your film positive. ![]() Line up the film positive to one piece of the printing paper then secure it with pieces of blue painter’s tape.Place your open silkscreen in the hinge clamps, securely tightening the clamps.Use masking tape to tape off the areas of the screen where there is no emulsion, tape both the front and back of the screen, making sure not to tape over the image.Label ink with student’s name and layer number.Mixing Ink: students should mix all three colors of ink prior to printing:.Review the Silkscreen Printing with Stencils Powerpoint as a class.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |